North Salt Lake Foundation Pros logoNorth Salt Lake Foundation ProsFoundation Repair · North Salt Lake, UT
Menu
driveway lifting in North Salt Lake, UT

North Salt Lake Foundation Pros

Driveway Lifting in North Salt Lake, UT

Driveway lifting in North Salt Lake, UT fixes sunken slabs at the garage line with foam injection, same-day drive-on, free estimates.

Serving North Salt Lake and nearby communities.

A driveway that's pulled away from the garage slab or dipped near the street usually means a void opened up underneath, not that the concrete itself failed. North Salt Lake sees that void form from freeze-thaw cycling under the slab edge and from runoff working its way under the pour during spring snowmelt. North Salt Lake Foundation Pros lifts the sunken panel back to grade with foam injection instead of pulling out the driveway and repouring it.

This is a slab-lifting job, not a foundation repair, so there's no excavation and no multi-day timeline. Small holes go in, foam goes under, the panel comes up, and the driveway is drivable again the same day .

What's included

What's Included with Driveway Lifting

Typically included

  • Inspection of the sunken panel and surrounding joints
  • Access holes drilled at calculated injection points
  • Polyurethane foam injection to raise and support the slab
  • Hole patching to match the surrounding surface

Optional

  • Joint resealing across the full driveway, not just the repaired panel
  • Surface sealant applied after the lift to resist future moisture intrusion

Customer prep

  • Clear vehicles and debris from the driveway before the crew arrives
  • Note any low spots or standing water patterns to point out during inspection

How it works

How Our Driveway Lifting Process Works

  1. Driveway Inspection photo
    Step 1

    Driveway Inspection

    Sunken or sloped sections are identified for correction.

  2. Access Drilling photo
    Step 2

    Access Drilling

    Small holes are drilled at strategic points along the driveway.

  3. Foam Injection photo
    Step 3

    Foam Injection

    Expanding foam is pumped beneath the slab to raise it evenly.

  4. Slope Correction photo
    Step 4

    Slope Correction

    The surface is adjusted to restore proper drainage direction.

  5. Hole Sealing photo
    Step 5

    Hole Sealing

    Drilled holes are patched to blend with the existing surface.

  6. Surface Review photo
    Step 6

    Surface Review

    The driveway is inspected for even, stable elevation.

Materials

Materials and Methods for Driveway Lifting

A driveway panel has to carry vehicle weight without re-settling, so the fill material and patch work matter as much as the lift itself.

  • Polyurethane Foam photo

    Polyurethane Foam

    Provides lightweight lift without adding excess weight to the soil, which matters on North Salt Lake's bench-to-valley fill where added mass can restart settlement.

  • Concrete Patch Mix photo

    Concrete Patch Mix

    Used to seal access holes after injection work for a flush, drivable finish.

  • Joint Sealant photo

    Joint Sealant

    Reseals expansion joints disturbed during the lifting process, keeping winter meltwater from re-entering the void.

  • Surface Sealer photo

    Surface Sealer

    Protects the driveway from moisture and future cracking through freeze-thaw seasons.

  • Leveling Equipment photo

    Leveling Equipment

    Ensures accurate measurement during the lifting procedure so the panel matches the garage slab height exactly.

  • Bonding Primer photo

    Bonding Primer

    Improves patch adhesion to the original concrete surface so repairs don't separate later.

Timeline

How Long Does a Driveway Lifting Take?

Most driveway lifting jobs wrap up in a single visit from inspection to drive-on.

  1. 01

    Inspection and markup

    same day
  2. 02

    Drilling and foam injection

    1–2 hours
  3. 03

    Patch cure before driving on it

    a few hours

Need a schedule that fits?

Get a Free Estimate

Cost

What Does a Driveway Lifting Cost in North Salt Lake?

Cost on a driveway lift tracks panel size and how many access points the foam needs to reach the full void, not the overall driveway length. Get a free estimate and a crew can give you an exact number after looking at the panel and the void underneath.

Project typeTypical rangeWhat’s included
Single panel lift$400–$900one sunken section near the garage or street apron.
Multi-panel lift$900–$2,200two or more panels raised in the same visit.
Full driveway releveling$2,200–$4,500slope correction across the whole slab run.

These are typical local ballparks — final cost depends on scope, materials, and site conditions. A free estimate gives you an accurate, itemized number for your home.

Want a number for your home?

Get a Free Estimate

Codes & permits

Permits and Codes for Driveway Lifting

Permit rules shift by jurisdiction, so confirm specifics with North Salt Lake or Davis County before work starts.

Typically needs a permitOften no permit
Work tied into a structural foundation repair on the same visitStandard foam injection lifting of an existing residential driveway slab
—Patch and seal work on access holes

DIY vs pro

DIY vs Hiring a Pro for Driveway Lifting

DIYHire a pro
Filling a hairline surface crack with store concrete crack fillerLifting a sunken panel back to grade
Sweeping polymeric sand into small joint gapsCorrecting slope so water drains away from the garage instead of pooling against it
—Any lift where the void extends under more than one panel

When to call

When to Call for Driveway Lifting

Call North Salt Lake Foundation Pros or request a free estimate before the gap widens through another winter.

  • A visible gap has opened between the driveway and the garage slab
  • One panel sits noticeably lower than its neighbor
  • Water pools on the driveway instead of running off toward the street

FAQs

Driveway Lifting FAQs

How much does driveway lifting cost in North Salt Lake?

Most single-panel lifts run $400–$900. Multi-panel jobs and full driveway releveling cost more depending on how many sections need foam.

How long does driveway lifting take?

A single panel typically takes 1-2 hours to drill, inject, and patch. The driveway is usually drivable the same day once the patch sets.

Do I need a permit for driveway lifting?

Standard slab lifting usually doesn't need a permit. If the work connects to structural foundation repair, a permit may apply.

Is DIY driveway lifting a good idea?

No. Lifting requires pressure-controlled injection equipment to raise the slab evenly without cracking it, which isn't a tool a homeowner has on hand.

When should I call a pro for driveway lifting?

Call once you see a gap at the garage threshold, a sunken panel, or water pooling instead of draining toward the street.

What affects driveway lifting pricing?

Panel count, void size, and whether slope correction is needed beyond the sunken section.

Does driveway lifting last as long as a full replacement?

Properly injected polyurethane foam resists water and won't break down the way soil fill does, so the lift holds as long as the slab itself stays sound.

What's typically included in a driveway lifting job?

Inspection, access drilling, foam injection, and hole patching are standard. Full-driveway slope correction is scoped separately if multiple panels are affected.

Ask about Driveway Lifting

Tell us about the project and how to reach you.

Call (435) 296-3740